I have the Dash POD out, along with the center console. I have removed one screw on the top side of the ignition switch, and could not find the other screw, I felt around but could not feel it. I think it must have been left out by the PO. The steering wheel is still connected, as it contains the air bag unit. What else needs to be removed in order for the ignition switch to come out so it can get replaced while I am in there.

Thanks
Harvey
---
if you have the 2 screws off the back of the switch, the wire plug is pulled off then then it should pull out.
MrMerlin
---

---
When I replaced mine, I had a heck of a time with the second screw (the one at 10:00 from the rear).
A mirror showed that a phillips head screw had been used instead of a slotted screw.
So I had one of each.

Good luck on this. I hope that the PO didn't use JB Weld.
__________________
Craig
---
i did use a mirror and there is no screw in the second slot. It appears that someone might have used some sort of sealant to keep it in place.

__________________
Harvey